DI-027: Midship Scantling & Transverse Frame Plan (Frames 36–74)
File: NOAAS-OCN_DI-027_Iss0001_R01_RevB_Midship_Scantlings.dwg (184.6 MB (14 Layout Sheets))
Parallel SME comments reconcile through the Discipline Lead and SDM before the Program Manager executes a single bundled Shipyard release.
Tabular Comment Ledger for DI-027 (3 Visible Rows)
Per Contract Spec Section 114.2 and ABS Rules Pt 3, Ch 2, revise Frame 48 multi-beam gondola transition bracket from a 15mm snipe to a 50mm radiused soft-toe bracket with 100% UT-inspected CJP weld prior to unit erection.
Toe radius at Frame 48 multi-beam sonar gondola transition bracket is drawn as sharp 15mm snipe; this will crack under North Pacific slamming loads. Make them put a 50mm soft-toe gusset with full-penetration ultrasonic weld.
Per Contract Spec Section 114.2 and ABS Rules for Building and Classing Marine Vessels Pt 3, Ch 2, revise the Frame 48 multi-beam gondola transition bracket from a 15mm snipe to a 50mm radiused soft-toe bracket with 100% UT-inspected CJP weld.
Per Contract Spec Section 114.2 and ABS Rules Pt 3, Ch 2, revise Frame 48 multi-beam gondola transition bracket from a 15mm snipe to a 50mm radiused soft-toe bracket with 100% UT-inspected CJP weld prior to unit erection.
Issued formally on R0: Provide 50mm soft-toe radius at Frame 48 sonar gondola bracket and specify 100% ultrasonic testing (UT) on the flange termination.
Shipyard Counter-Comment: In R01 Sheet 04 we increased bracket plate thickness from 14mm to 18mm AH36, but kept a 25mm snipe to clear the 150mm bilge ballast suction pipe penetration.
Government Back-Check Disposition: Non-concur with 25mm snipe. Offset ballast pipe collar 65mm inboard or install collar doubler ring so full 50mm fatigue radius is preserved. Comment remains OPEN in R01.
Verify bolt-circle alignment between Sheet 09 A-frame winch foundation insert plate (DH36, 20mm) and Vendor Furnished Information drawing VFI-309 Rev A (+/- 2mm tolerance). [Held in Government Drafting Gate awaiting PM release]
Update Sheet 02 Weld Schedule Table 2.1 to specify AWS E7018-H4R low-hydrogen consumable for all ABS Ice Class D0 ice-belt shell seams.
